Combo with 139mm Trucks, Wheels, Bearings

My daughters wheel could have fallen off the first time! We popped these on her board and she went for a ride down the hill by the time she got to the bottom realized that the bolt was completely missing. The wheel was almost off thank goodness she realized it was wobbling before it became a disaster. We are on a pretty steep grade and she could’ve been seriously injured. We are constantly re-tightening them but they just loosen back up again.

The axle threads do not stick out far enough to adequately allow the nut to attach and tighten properly. No instructions came with the package, so we had to go online to find videos on how to do this. Written instructions are needed. We tried to put it together but were unable to due to improper length of the axle threads.

You really do get what you pay for. Everything about it is decent. Good for skatepark skaters who like loose trucks. As a beginner skater, I bought this to save money not knowing too much about skating. I ended up just spending more money though for better wheels and bushings. The bushings were really soft to where you would get wheel bite if you turned a little funny which makes it hard to power slide. The wheels were terrible for concrete and rough surfaces. If the floor wasn't well paved, the wheels didn't really skate well. I skated on a slightly elevated hill with a penny board and would go pretty fast and smooth but I put these on my skateboard and was barely rolling down that same hill. Overall a good package deal for the price, and it even comes with riser pads. However, I would just recommend buying higher quality parts.

Bought these for my son, he compared these to reds, not sure what that means, but I took it as that was a good thing.. will be buying more for his next boards.

My 8yr old son inherited a very nice skateboard from a neighbor. Problem was the board was set up for much heavier & more experienced rider. So, got this set & switched them out. These have a lot softer bushings & wheels. Let my son turn & control board better.NOTE: Seen many comments on bearings not going in far enough to put nuts on. You need to push the bearings in until they are tight against spacer. I push them in enough to get nut started. Then tighten them down until so tight wheels don't spin well. Lossen until you have the spin speed you want. (As my son is still learning a little resistance is not a bad thing.)Very nice set, P.S. my twin girls have Cal-7 boards & they love them - Good Brand

Great price to get my kid started with skateboarding...quality is decent for the price. I did have a few holes that were not completely drilled out. I was able to pop them out without too much difficulty.

The product came neatly organized in a small compact box which I appreciated very much. It featured most of the hardware that I needed to complete my skateboard. The parts seemed to be of okay quality; not the best but will do for a starter skateboard.Also the set would have been best if it featured the grip tape but I know that they didn't advertise it on there. It was rather inconvenient that I had to purchase the grip tape from a different vendor.

Bought these for a secret Santa thing my work was having for impoverished children. The trucks seemed cheap but good for beginner. Didn’t hate the wheels. Bearings are ok. This is overall a good setup for a parent to buy to see if their kids will stick with it. Only recommendation is to TIGHTEN THE KINGPINS!! Too loose!!

Good starter set to help with board swapping and repairing.