VIOFOHK3 ACC Hardwire Kit for A129, A129 Plus, A129 PRO, A129 IR, A119 V3, Enables Parking Mode, Low Voltage Protection

Bought this for my 1984 car. As other reviews have pointed out, this kit does not come with any fuse taps, Instead just bare wire for you to install, either into fuse taps. Or in my case, crimp ring terminals in and install into my own fuse box.As such I would say this is perfect for me, not buying anything I would not need, however I am aware my install would be a rare case.I have the voltage selector set to the highest voltage, I have had no issues starting the car after the camera has been in parking mode for over 24h

Hardwire kit was easy to install just follow instructions job done

Mechanic saw no issues

***You will need to buy the correct Fuse Taps for your car before installing.***I bought this kit as my Skoda Karoq has always on accessories ports (cigarette lighter & USB C ports its the most annoying thing about the car!) After my dash cam ran my battery down on 3 seperate occasions I did some research online and found other people with the same issue. They had overcome this by buying a wired in kit and using the back wiper fuse as the accessory wire and the 12v accessory fuse as the battery power. So I though I would give it a go so I bought this kit along with some low profile Fuse Taps that fit my Skoda Karoq. I read online that you needed 5 amp fuses so I made sure I got Fuse Taps which came with a variety of fuses.Install the Fuse Taps first to check they were working, then attached the ground and crimped the kits cables to the Fuse Taps and tested to check the dash cam had power. Everything worked perfectly. I then routed the cables around the window and tidied the cables away so that they couldn't be seen. All in all this took about 20 minutes to install. The only two complaint I have is the placement of the ferrite core stopped me from fully hiding the cable and the lack of explanation of the switches on the kit two what voltage to set the device to.However, the dash cam now comes on when the car starts and goes off with the car. Hopefully this should now stop my battery from being drained in the future.

This was simple to install when purchased alongside fuse tap connectors, I simply picked a live fuse using a multi-meter when the car was off.It has safely kept my battery from draining while running the dash cam since!

It works, bit it's the 3rd one I've had to purchase in 3 years, as the main battery power is not sent from the controller box to the cam mounting plate but still has the supply to it.Also, see picture, their quality control needs to be quality controlled! The stickers on the cables are incorrect. The instructions are right though and common sense would hopefully prevail with most people that feel they have the knowledge and knowhow to do this job.Let's hope this one lasts.

Does the job for my Viofo A129.You may need to buy fuse tap off connectors separately for your car, or you can splice wires. But once fitted you can forget about it.It allows me to use 'parking mode' on my camera so I can keep an eye on what's going on around my car when parked on the street on a night.The only downside was that the ferrite ring noise suppressor near the usb plug got in the way of my particular installation, I couldn't tuck it behind the trim like I wanted

If you don't like wires trailing about all over your das then this is the solution.