Mini Split Bracket for Ductless Air Conditioner Wall Mounting 7000 - 15000 BTU

Works great with our 18000 btu mrcool unit very solid

This mini split condenser bracket arrived quickly and was packaged as to protect it on the way. The bracket was easy to install and is of quality material that should hold up for years to come. I used these brackets on a dual unit and a single condenser and they helped me with reducing the visibility and my use of space.

These worked perfectly for the new mini split system I installed on one of my rental homes. The holes lined right up perfectly the installation of them were a cakewalk and try hold a great amount of weight as well ! They give great support to the unit that they are supporting! Will most definitely be purchasing more for any other units i purchase for my other houses

I didn't want to put my mini split on the ground to reduce water and dirt splashing on and into the unit during rain so I opted for a wall mount instead. This mount was easy to install and seems very sturdy. I took one star off because I had to completely remove the rubber guard on the vertical part of the brackets to get it close to being level. Instead, I put some very thin flashing tape behind them to prevent metal-on-stone scraping. And yes, I made sure it's not the wall that's out of plumb ;)

These brackets works great on my mini-split. These were installed several months ago and they are still holding up.

The brackets are definitely strong enough and they have a pretty durable finish. The mounting bolts are a bit overkill if you're mounting to a wood sided wall. I sealed mine out for a little shorter stainless steel lag bolts. The bolts supplied for mounting the compressor are too short to allow for lock washers so I swapped them for some longer stainless bolts as well. Still a good investment.

This is a great mount and so far is holding my 18k MrCool condenser perfectly. Due to it being only 30” wide, only the middle 2 bolts can attach to typical 16” stud placements. I do not recommend using the included anchors. With how heavy this condenser is, and the value of it, all 4 bolts should really be in wood. I’m mounting to stucco, so the anchors wouldn’t have done much anyway. I added some cross studs for the 2 outer bolts, which was a pain as I had to cut into my drywall to do so. If you’re mounting inside an unfinished garage or wall, then that step is a little easier. If this had only been 32” wide you could have probably gotten away with mounting 3 bolts to the studs and a 4th for security somewhere, but alas. Nevertheless, with some forethought, this works great…

These work as designed. Multiple mounting options. Much cheaper than going to the local big box store and buying them.