DC Power Fuse Distribution Strip Module (6 Position, DIN Rail Mount)

Ideal for a ham radio shack. Power distribution for your low-current devices. The LED's are cute. If the fuse is blow, there is a little LED that glows red. Uses standard spade fuses like you find in your car. I use it to drive my SWR meter, my little LED desk light and i change out one fuse to a 20A fuse for my mobile rig i use on the bench.The value for what it is is amazing. installation is quick and painless.

So far this little board is awesome.I am running a garmin graph, wireless relay controlling 3 led lights.Makes setup of a power distribution box a piece of cake.

Great fused terminal block for multiple DC power distribution. Perfect for access control systems in order to separately fuse each door.

This was what I was looking for, for DC fuse block for my square drop camper build.

Great for a 12 volt camera system setup. I should have gone POE, but I bought my cameras before that was readily available, so I had to wire my house with 12 volts. I like the individual fuses, as it protects any wiring from arcing or damage in the attic. I added a few higher rated fuses, and am able to run 12 volt stuff all over the house without those stupid "wall warts" too, so that's a major plus. The DIN rail connector makes it really easy to install.I have a few other products made by this company, and they're all very good.I would highly recommend this product.

Port 1 does not work. Port 2 through 12 do work. If I pull the fuse on port 1, there is still voltage present. No sure what the issue is. Also if I add a 12v load on port 1. The voltage drops to 4v.

I used this for 5vdc distribution block and it worked better than expected.

Good product